Heilongjiang Nongken Hengyun Agricultural Machinery Manufacturing Co。, Ltd。
Recruitment agents everywhere
Contact: Mr. Song
Address: Shuguang farm, Huanan County, Heilongjiang province.
The most common problem in the adjustment of hydraulic overturning plough is the adjustment between the overturning plough and the tractor. First, check whether the tractor and the plough are too high. If it is too high, it should be lowered to the appropriate depth of plough into the soil, and then shorten the length of the central pull rod to increase the angle of plough into the soil. The position of the limit wheel can also be moved backward from the position corresponding to the second plough post to the position between the second plough and the third plough post. In addition, the thickness of the ploughshare blade exceeds 3mm to be forged or sharpened, otherwise it will not be easy to enter the soil. Tractor tillage easy to run off the adjustment: first adjust the plough hook, so that three-point suspension in the center of the tractor, and ensure that the two lifting arms and tractor tire inside the same size, and then adjust the distance between plough columns on the plough rack to meet the requirements of the same size.
The adjustment method of the limit plate bolt of the plough reversal plough: The limit plate adjustment bolt on both sides of the cross beam of the plough suspension frame is used to adjust the balance between the left and the right of the plough frame。 When ploughing, take the horizon as the reference object, observe whether the plough frame is parallel, if not parallel, adjust the plough frame parallelism by tightening or loosening the adjustment bolt。 It should be noted that after adjusting one side, the other side should be adjusted in the same way, so as to achieve the same effect of turning left and right。 Without tillage, the plough frame is not parallel, and a certain slope is normal。